Jump to content

Black Prince (tank)

From Wikipedia, the free encyclopedia

Tank, Infantry, Black Prince
Side view of the prototype A43 Black Prince
TypeInfantry tank
Place of originUnited Kingdom
Production history
DesignerVauxhall
Designed1943
ManufacturerVauxhall
Produced1945
No. built6 prototypes
Specifications
Mass50 long tons (51 t)[1]
Length28 ft 11 in (8.81 m)[1]
Width11 ft 3.5 in (3.442 m)[1]
Height9 ft (2.7 m)[1]
Crew5 (Commander, gunner, loader, driver, hull gunner)

Armour152 mm (6.0 in) Front
Main
armament
QF 17 pdr with 89 rounds
Secondary
armament
2 × 7.92 mm Besa machine guns
EngineBedford Type 120 horizontally opposed 12-cylinder
350 hp (260 kW)
Power/weight7 hp/ton
Suspensionsprung bogie
Operational
range
about 100 mi (160 km)
Maximum speed 10.5 mph (16.9 km/h) on road
7.5 mph (12.1 km/h) off-road

Tank, Infantry, Black Prince (A43) is the name that was assigned to an experimental development of the Churchill tank with a larger, wider hull and a QF 17-pounder (76.2 mm) gun. It was named after Edward, the Black Prince, son of Edward III and heir to the English throne.

Development

[edit]

As a development from the Churchill, the Black Prince was a continuation of the line of Infantry tanks, that is slower, heavier tanks intended to operate in close support of infantry. It also was able to work closely with other tanks. The parallel development in British tank design were the Cruiser tanks, which were intended for more mobile operations. A43 was the General Staff Specification number issued in 1943, for an interim tank that would eventually be superseded by a "Universal tank" that would replace both Infantry and Cruiser tanks.[2]

The cruiser line led to the Cromwell and its 17 pounder-armed Challenger variant, eventually followed by the Comet equipped with the 77 mm gun firing similar ammunition to the 17 pounder. These tanks entered service during the war. While not as heavily protected as the Churchill, the Comet showed the way British tank development was going. This led to the last of the cruiser line and the first of the Universal tanks (now more widely known as main battle tanks), the very successful Centurion.

A larger gun than that carried by a conventional Churchill required a larger turret on a wider turret ring and consequently a widening of the tank hull. The Black Prince weighed around ten tons more than the Churchill so the suspension was modified and the tracks widened by 10 inches to carry the extra load. However, the Churchill's 350-horsepower (260 kW) engine was retained, leading to the tank being underpowered and slow, with maximum speeds 10.5 mph (16.9 km/h) on roads and 7.5 mph (12.1 km/h) cross country. This was so slow that the tank's tactical usefulness would have been limited.[2] Consideration was given to the use of the Rolls-Royce Meteor engine; this would have increased the available power to 600 hp (450 kW), but the idea never left the drawing–board.[2] Likewise, plans to fit the Black Prince with the turret from the Centurion were never carried out.[2]

By the time the Black Prince prototypes had appeared in May 1945, the 17-pounder armed Sherman Firefly had proved itself in combat, the Comet tank was in service and the introduction of Centurion was imminent. All these tanks carried the QF 17-pounder or an equivalent; all had better mobility than the Black Prince and the Centurion had frontal armour of comparable effectiveness.[Note 1] The Black Prince had become redundant and the project was abandoned.[2]

The Black Prince marked the end of the development of the A22F Churchill Mk VII, and the end of the Infantry tank concept in British tank design.

Survivors

[edit]
Black Prince prototype number four, at The Tank Museum (2008). The red-painted frame on the turret top is a sighting vane to allow rough but quick alignment of the gun in traverse when viewed through the commander's periscope

The only intact Black Prince is held by The Tank Museum in Bovington, UK; it is the fourth of the six prototypes that were built. It has recently been restored to running condition.[3] A Black Prince hull was recovered from Salisbury Plain in the 1980s as part of the Tony Budge Collection, and is now held by the Rex and Rod Cadman Collection.[4]

See also

[edit]

Notes

[edit]
  1. ^ The Centurion had thinner, 101-millimetre (4.0 in), frontal armour but it was sloped increasing its effective protection.

References

[edit]
Citations
  1. ^ a b c d White p71
  2. ^ a b c d e Mike Garth. "Tank Infantry A43, Black Prince (E1949.359)". The Tank Museum. Retrieved 3 June 2012.
  3. ^ "Tankfest 2012 Update". The Tank Museum. 27 April 2012. Archived from the original on 13 May 2012. Retrieved 3 June 2012.
  4. ^ "A43 Black Prince".
Bibliography
  • White, B T British Tanks 1915-1945
[edit]